TCP/IP communication
-
I have my own application running on a Windows Mobile 6.5 device.I have installed Navigator Free 12 and can successfully send commands via TCP/IP such as $restore.However my application has UK addresses with a Postcode. I would like to automate Navigator to Restore then to navigate to an address ideally with just the postcode.Looking at the documentation I can use $destination with coordinates, is there something I am missing? Is this feature in the licensed version by any chance?CheersChris
-
1 Comment sorted by
-
Hello Chris,
at the moment the $destination command with UK postcodes is supported only in commercial version (or better to say with commercial maps of UK).
regards
Martin
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions3,246
- Feature Requests1,264
- Bugs555
- General376
- Navigator FREE1,029
- Vehicle Tracking5
- Navigator 1017
In this Discussion
- mdx April 2013