MapFactor Forum

*Vote Up*

Hi Tomas, Stepan,

In Vehicle Profile, the urban speed is not used in the route calculation.

Only extra-urban speed is used.

The city streets(minor or major or others) are considered to be outside the city.

If you change the urban speed, there is no change of route in city.

If you change the extra-urban speed, there is a change of route even in city.

Please watch the problem.

Thx.

*Vote Up*

please give example

*Vote Up*

Hi Tomas,

Exemple :

*Vote Up*

Another example :

*Vote Up*

I looked at your first example - it works as it should, but you need to reduce speed for Local connecting road

*Vote Up*

please give example

*Vote Up*

*Vote Up*

And :

*Vote Up*

Local connecting road is Route Departmentale Pricipale in your screenshots

*Vote Up*

The speed limits are reversed for the calculation !

If I decrease the speed in the city, it is to avoid the city and favor the outside of the city, because it is faster than crossing the city.

And there, the opposite occurs, even with the "Local connecting road"

And Optimisation Mode is "Fastest"

*Vote Up*

with default car settings, reducing urban speed for local road of high importance and local road, I get route via Route de Saumur

so I think there is some other settings in your profile, possibly preferences?

*Vote Up*

No, i use Default car setting....

Give me the values you put or a screenshot would be good for testing.

*Vote Up*

I am convinced that the speed limits are reversed for the calculation, looking at the limits inside and outside the city and the calculated routes.

Even if you reduce the speed in the city, as you tell me, there is a problem, isn't it !?

*Vote Up*

Defaut Car setting with urban speed limite 30 km/h

*Vote Up*

The problems result from the fact that MFN incorrectly treats urban roads as extra-urban roads, as is so often the case.

In the examples of @MacDony, all roads, even those in the middle of the villages, are treated as extra-urban.

@Tomas, @Stepan, how does Navigator decide whether a road is urban or extra-urban?

*Vote Up*

sorry, I just realised I did not have default car settings

with default car settings I get the same result as you

however, reducing speed works, as 280s is route time with default and 295s when speed is reduced

295s is still faster the going around

it could be problem at our end with map production, or with OSM map data

I will pass it on to developers to look at

*Vote Up*

Thanks.

*Vote Up*

Hi,

I changed the Urban and Extra-Urban speeds to see if there were differences with fast speeds.

And I noticed something.

I do tests and I tell you again.

*Vote Up*

Delfin is right,

All the OSM roads I tested are treated as Extra-Urban.

To temporarily correct this problem, I put these settings that work on most trips.

*Vote Up*

Hi all,
We know that Navigator does not use the "Urban road" settings.
So logically, if I set the "Urban road" parameters to "0" that should not change the calculation of a route!
But this is not the case .... the calculation is totally different ?!
Any idea why?

*Vote Up*

in order that road is considered urban it must be in urban area

unfortunately urban areas are frequently not covering road links in OSM

*Vote Up*

Ok, Thx Tomas.

MapFactor Forum

Howdy, Stranger!

Categories

In this Discussion