HELLO i installed mapfactor navigator on sd card and trying to run it on a windows embedded 7 device which uses port 11 for gps how can i change that???
Ok just one more question please Im trying to run navigator on a device with resolution 800x480 WINCE 6.0 (China 2DIN) 256 mb ram and idk the other tech data.
THE PROBLEM IS UNTIL I GET TO THE HOME SCREEN EVERYTHING WORKS FINE, THEN I CANT SEE NOTHING THE SCREEN GOES BLACK AND THE DEVICE SLOWS DOWN UNTIL I REBOOT IT AND WHEN I TRY TO START NAVIGATOR AGAIN THE LOADING SCREEN IS ON BUT WHEN THE SOFTWARE LOADS I GET THE SAME PROBLEM BLACK SCREEN EVEN THOUGH THE NAVIGATOR IS RUNNING BECAUSE IT FLASHES FOR 1-2 SEC SOMETIMES AND I CAN SEE THE BUTTONS AND THE WORLD MAP THAT APPEARS.
Is there a way to modify the resolution in PC so i can run it on my WINCE UNIT????
Deleted the file but no luck same problem :( Other navigation software like iGo run with no problem but i had mapfactor navigator for a long while in my phone and im used to it.
I do not see black screen what I see is that Navigator does not start, probably because you do not have all files installed (one was mentioned in your video) install Navigator again from Setup utilities it could, of course, be faulty SD
I tried reinstalling it approx 50 times and i tried 6 different SD cards 4 of them new SD cards and with different sizes, also running another navigation with the same SD it works . All the SD im trying are class 10 ones. I always get the localisation_ch.dll missing I can upload another video to show how im doing the installation to SD card so you can see if im doing it right or not.
Hmmmm i think i was overreacting at the part where the navigator flashes its that it is restarting after the first run. I turned the device off then on again and when i pres Navigation voila its running perfect. The only "problem" now is the arrow, but i seen a solutuon somewhere in MFN forum. Thank you for your help