Configure display format of panel data
-
When I add “Time to destination” in the android version of Navigator it will always show the time including seconds. The display format is always: hh:mm:ss. But in PC Navigator it will not show the seconds if the route takes longer than one hour. The format is hh:mm. When the route takes less than one hour then seconds are shown, the format in this case is: mm:ss.Could it be possible to make this display format configurable? Because personally I never want to see the seconds, because this makes the “Time to destination” hard to see on a small screen.
-
1 Comment sorted by
-
+1. We had this earlier in this forum as well.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions3,246
- Feature Requests1,264
- Bugs555
- General376
- Navigator FREE1,029
- Vehicle Tracking5
- Navigator 1017
In this Discussion
- Oldie November 2015